586,770 active members*
9,196 visitors online*
Register for free
Login

Thread: stepper drivers

Results 1 to 2 of 2
  1. 01-19-2004, 07:34 AM #1
    DDM
    DDM is offline Registered
    Send a message via MSN to DDM
    Join Date
    Nov 2003
    Posts
    181

    stepper drivers

    Hey I was looking on the Camtronics website tonight and saw that they had 692 oz in stepper motors. Now fo the loaded question would it be posible to run these steppers with the xylotex driver in series I see that it would be possible to do it with that driver because the amps are under 2.5 or am I way off base here? It would be nice to be able to start off with that driver and then If I wanted to in the future switch to the geckos. I want to get some good size motors right now instead of buying something that is too weak and I think that for my application the Nema 34 frame is the way to go instead of going with the 23's and then having to make new mounting blocks and couplers.

    Thanks,
    Carl
    Reply With Quote Reply With Quote
  2. 01-19-2004, 07:58 AM #2
    DDM
    DDM is offline Registered
    Send a message via MSN to DDM
    Join Date
    Nov 2003
    Posts
    181
    Forgot to add in the specs on the motors

    8 leads, 692 oz in, 5.3 volts series, 2.75 volts parallel,
    2.4A Series, 5A parallel
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Open Source Boards Available, Stepper Drivers and Break Out Boards
    By pminmo in forum Open Source Controller Boards
    Replies: 762
    Last Post: 06-23-2018, 01:46 AM
  2. Great value stepper drivers
    By xairflyer in forum Stepper Motors / Drives
    Replies: 15
    Last Post: 05-31-2008, 03:14 PM
  3. Have existing stepper motors but want to replace control board with integral drivers.
    By Gerald_D in forum CNC Machine Related Electronics
    Replies: 3
    Last Post: 05-22-2005, 03:55 PM
  4. stepper drivers
    By Nilesh in forum CNC Machine Related Electronics
    Replies: 3
    Last Post: 06-23-2004, 02:05 AM
  5. Possible CHEAP drivers, stepper and/or servo
    By NeoMoses in forum CNC Machine Related Electronics
    Replies: 5
    Last Post: 03-23-2004, 08:45 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules