586,481 active members*
2,243 visitors online*
Register for free
Login

Thread: Sabre VMC with Fanuc 0M

Results 1 to 2 of 2
  1. 05-03-2015, 11:46 AM #1
    M.RISHIKESH
    M.RISHIKESH is offline Registered
    Join Date
    Dec 2006
    Posts
    310

    Sabre VMC with Fanuc 0M

    Sir
    Subject machine was running fine till last
    Wednesday after that even if jog feed rate
    Switch kept at 10%, when either of the three axes are jogged, selected axis moves at alarmingly high speed. We don't find any loose connections in motor drive cbc etc. We don't doubt parameters etc as machine was quite normal till Wednesday
    Kindly advice
    Warm regards
    Reply With Quote Reply With Quote
  2. 08-18-2015, 07:16 PM #2
    sansgp
    sansgp is offline Junior Member
    Join Date
    Oct 2008
    Posts
    29

    Re: Sabre VMC with Fanuc 0M

    Fault may be with the feed rate selector switch. you may check the switch status on the diagnostic screen.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Fanuc 0M - Sabre
    By M.RISHIKESH in forum Fanuc
    Replies: 1
    Last Post: 08-22-2014, 02:06 PM
  2. Alarms on SABRE 750 with FANUC O-M
    By nsdjole in forum Cincinnati CNC
    Replies: 7
    Last Post: 03-27-2014, 07:13 PM
  3. Cincinnati Sabre 1250 with Fanuc 0-M
    By NetblindPaul in forum Cincinnati CNC
    Replies: 2
    Last Post: 11-28-2013, 10:05 PM
  4. Anybody have an older Sabre with Fanuc OM control?
    By laka in forum Cincinnati CNC
    Replies: 1
    Last Post: 12-05-2012, 02:51 PM
  5. Fanuc vs Acramatic Sabre 750
    By laka in forum Cincinnati CNC
    Replies: 0
    Last Post: 08-12-2011, 08:03 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules