Who ever did the conversion on my mill had it setup with a 220 plug, and a handful of 110 plugs. I finally redid all of the electrical and wired it for a single 220 plug with a neutral. For the outlet, I just pulled new wire and added the neutral to my outlet. You could probably even just pull a neutral wire, and leave the rest.
Results 1 to 20 of 125
Threaded View
-
04-30-2015, 05:13 PM #11
Registered
- Join Date
- Dec 2013
- Posts
- 290
Re: Looking to pull the CNC conversion trigger
Reply With QuoteSimilar Threads
-
Considering a PlasmaCam,should I pull the trigger?
By Alleykat in forum PlasmaCamReplies: 17Last Post: 05-05-2017, 01:22 AM -
Before I pull the trigger on a build .
By Kru82 in forum DIY CNC Router Table MachinesReplies: 17Last Post: 03-07-2015, 10:02 PM -
About to pull the trigger but have questions.
By phylo in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 04-20-2012, 06:06 PM -
About to pull the trigger on a Grizzly G0602
By akschu in forum Uncategorised MetalWorking MachinesReplies: 3Last Post: 08-28-2008, 09:36 PM -
RFQ trigger and block....
By impact in forum Employment OpportunityReplies: 8Last Post: 11-04-2004, 07:51 AM
Tags for this Thread
Posting Permissions
