we have a Metal Master Plus, and recently we have been getting lots of terminal faults, for example 5202 DRV fault on drive amp (Xa), and 5625 HL1: cnc kernel drv error, and 5627 HL1: error executing manual command. All signs point to a gantry that is out of square. Today i got the gantry pulled square, but i think that when you release the drives, the gantry should remain in a relaxed state, not spring back to where it wants to be.
has anyone tried to square up a gantry before? if so, how should i proceed?
Results 1 to 3 of 3
-
03-06-2014, 02:41 PM #1
Registered
- Join Date
- Jul 2013
- Posts
- 32
Messer burn table gantry not square
-
03-11-2014, 05:14 AM #2
Registered
- Join Date
- Sep 2012
- Posts
- 74
what type of mounts do you have are they bolted to the floor or are they built onto the table?
-
04-22-2015, 12:25 PM #3
Registered
- Join Date
- Jul 2013
- Posts
- 32
Re: Messer burn table gantry not square
@jason_alex.
the gantry is mounted over the slagger table. i found that the master drive motor was pulling in nice and easy to the meshing gears, but the slave axis had to be manually bumped ahead so the gears would mesh properly. since we adjusted it, there have been no faults.
Reply With QuoteSimilar Threads
-
Need help extending older Messer table with Burny 2.8Plus controller
By Tilley in forum CNC Plasma / Oxy Fuel Cutting MachinesReplies: 2Last Post: 04-28-2014, 08:26 PM -
Burn Table Lead Out of Zero ERROR
By JINDA in forum BobCad-CamReplies: 2Last Post: 05-10-2012, 06:33 PM -
Need help with Messer table Burny control
By kputer in forum DIY CNC Router Table MachinesReplies: 0Last Post: 07-20-2011, 09:34 PM -
Squaring a gantry - without a square?
By Instance in forum DIY CNC Router Table MachinesReplies: 3Last Post: 01-20-2011, 09:37 AM -
is there an easy way to square a gantry?
By 15mgtar in forum DIY CNC Router Table MachinesReplies: 6Last Post: 06-21-2010, 06:40 PM
Tags for this Thread
Posting Permissions
