Originally Posted by
oeindustrial
Hi everyone! I wanted to start by saying thanks for creating such an awesome resource for CNC enthusiasts. Seriously, there's a powerful community here! I've been lurking and checking out a bit of the other posts for a bit now, and just decided to register because I came to a challenge that stumped me!
I have the Eltee Pulsitron TRM21/EP300CP and the Z-Axis is frozen in place on the machine. I have tried changing the drive to the unit, but no luck. If you need any other information, I will do my best to get it to you.
I was wondering if anyone here had any troubleshooting suggestions or could point me in the right direction to get this bad boy moving again? If so, that would be perfect! I would be extremely grateful for any advice or guidance anyone can give.
Thanks in advance for your time and wisdom!
Best regards,
Mass