Hi everyone!
I am new here and do not know if this is going into the right area or not so I will ask questions...probably lots. I plan on machining aluminum and steel with it.

I bought a TMC 100 mill at an auction. It was very reasonably priced so I plan on spending some money to get his machine living again. It came with no power supply or software. So my 1st question is... what is a good kit or set up that will get this thing up and running quickly ? I have limited machining and electronics knowledge. I have read about the Gecko 540 and a few other things but I was hoping anyone with knowledge could guide me towards the best stepper motors to use. I would like a double shaft to allow to add hand wheels at a certain point.I need something that is pretty much plug and play as I do not want to spend a lot of time putting this machine together. Anyone with experience with this mill or the guidance for the proper set up I will need is greatly appreciated.
Thank you