[tony978]

hi ,
I am running an old ultimax vmc and using mastercam 8 hurco post . I get a movement out of travel error when using h offset and D comp is not doing anything . I have run in to this in years past with another machine .
does anyone know why this is ?
thank you
tony

[stucapco]

Sample of the code please?

[tony978]

G42 and h on same line and d is under


Tony

Sent from my iPhone using Tapatalk

[stucapco]

Off the top of my head...

O0001;
G90 G54 X0 Y0 S500 M3;
G43 H1 Z.05. M8;
G01 Z-1. F1.;
G01 X-.5 G42 D1;
G02 I.5;
G01 X0 G40;
G00 Z1. M9;

Something like this? Rough mill, one inch deep, one inch circle, assuming the correct TLO and cutter compensation.

Working blind here, I hope i'm helping.

I would climb mill BTW, IE: G41 G03 etc...

edit, I assume there is rough clearance on center allowing the EM to rapid to Z-1.

CNC, I'f your wrong it WILL explain it to you in a big way. This is so much fun!

[tony978]

My post doesn't have ; at the end . But that looks like the format I am running .

Edit : thank you ! Maybe it is ;


Tony

Sent from my iPhone using Tapatalk

[stucapco]

; = end of block (end of thought relative to it's NC code family)

good luck man!

You can do EEEET!

[tony978]

Ya I have seen it on kitamura's just not hurco


Tony

Sent from my iPhone using Tapatalk

[tony978]

The problem is it is the old Hurco with one tool offset page , meaning 01 is just a variable and can be the same as hight number and dia . So 1 is not tool it is var 1 (h1 then d different number )


Tony

Sent from my iPhone using Tapatalk