Has anyone modified the Mach3 post in CamBam to fit Path Pilot.
Dave
Has anyone modified the Mach3 post in CamBam to fit Path Pilot.
Dave
Does CamBam have a LinuxCNC or EMC post? Either of those might work with PathPilot.
Michael
Yes CamBam does have a post for LinuxCNC. The trouble I am finding is both the Mach3 and LinuxCNC post do not have the M998 tool change or do they do tool length comp with a G43 Hx SprutCAM9 Mach3 post does both but I like using CamBam for simple 2.5D machining.
I guess that I'll just have to use SprutCAM9 for every thing.
Dave
EMC seems to us G30 for instead of M998 and seems to work good. This is from HSMXpress though, but I would think it would work the same.
Donald