I have an 80's vintage Ikegai ft20U with a Fanuc 6t B controller, that I am trying to program the live tooling on. My manual gives me little guidance. I have learned that I invoke milling mode by commanding M18. After doing so however I am lost. I can command a M29 C/H__ (spindle orientation) and it orients the spindle, but then it just sits there until I hit reset. the cycle start light stays lit, no alarm, as if it is waiting for some additional command or signal. When I command a tool move such as G01 X__, it just sits there, no axis movement and the cycle start light illuminated but no movement until I hit the reset button. Any suggestions would be welcome or if anyone knows where I could find a program or a manual on programming the rotary tool on this old beast I would appreciate it.