Hello,
I've got a Doosan VMC 4020 with a Fanuc control 21i-MB. I've been trying to load new programs into the machine, but I haven't been able to. I can reload older programs that are already on the flash card. I've become to believe that the problem is in the way my format is or the way the file is saved. Has anyone had this problem before with these machines? So far we've gotten away with older programs, but time is running out.
Here is a sample of one of the problem programs.
%
O3253 ( 153253 - NAMEBOARD ANGLE )
(XY ZERO BACK LT CORNER)
(Z ZERO TOP SURFACE)
(DRILL - ENDMILL)
N10 G20
N15 G0 G90 G80 G40 G17 G94
N20 G91 G28 Z0
N25 G90
N30 T43 M6 (DRILL, HSS - .563")
(DRILL .563 THRU)
N35 G0 G90 G54 X2.5315 Y-3.25 S600 M3
N40 G43 H43 Z1. T24
N45 G99 G81 Z-.794 R1. F6.
N50 X3.4685
N55 G0 Z4.
N60 G91 G28 Z0 M9
N65 G90
N70 M1
N75 T24 M6
(INTERPOLATE SLOT)
N80 G0 G90 G54 X3.4685 Y-3.25 S400 M3
N85 G43 H24 Z.925 T0
N90 G1 Z.125 F20.
N95 G1 G41 D01 X3.0008 Y-3.2185
N100 X3.
~~
~~
N330 X2.9992
N335 G40 X2.5315 Y-3.25
N340 Z.925
N345 G0 G91 G28 Z0 M9
N350 G28 Y0
N355 M30
%
John