How do I flag a tool number in the program so that it will count in Table A of the tool wear page labeled( number of work pieces)? Do I need to replace the T0202 With something else? Any Ideas are welcome The manual is not much help!!
Thread: Okuma OSP-100L TOOL WEAR TABLE A
Results 1 to 5 of 5
Threaded View
-
03-26-2015, 06:26 PM #1
Registered
- Join Date
- Jun 2014
- Posts
- 3
Okuma OSP-100L TOOL WEAR TABLE A
Reply With QuoteSimilar Threads
-
Tool Wear
By rckdef in forum Haas MillsReplies: 9Last Post: 08-09-2014, 01:32 PM -
Tool Wear Adjustment
By nfrees114 in forum Haas MillsReplies: 8Last Post: 08-08-2014, 01:04 AM -
Posting half the tool radius for cutter comp instead of zero for tool wear.
By camtd in forum UG NXReplies: 2Last Post: 02-11-2014, 01:17 PM -
Fanuc 0-T Tool wear / tool length compensation problem
By Beliathan in forum FanucReplies: 7Last Post: 01-23-2013, 05:46 PM -
tool wear indicater
By Vern Smith in forum Haas MillsReplies: 13Last Post: 03-20-2007, 07:09 PM
Tags for this Thread
Posting Permissions
