I received my 4 axis drive with power supply. I set the power supply output voltage and now want to set the drive output. Do I need to be connected to a computer
with a program running to do this? It seems like I might by the instruction
sheet. I'm a bit confused. The instructions create a lot of questions for me. I read back to Aug of 2005 on this and can't seem to get clear answers and some of the questions were not answered at all by others.
Thread: Setting Vref---when?
Results 1 to 3 of 3
-
10-25-2006, 02:45 AM #1
Registered
- Join Date
- Jun 2006
- Posts
- 217
Setting Vref---when?
-
10-25-2006, 11:15 AM #2
Community Moderator
- Join Date
- Mar 2003
- Posts
- 35538
Did you read this? http://www.xylotex.com/Setup%20Instructions.htm
Steps 7,8, and 9. You don't even need the board connected to the computer to set the VREF. (Step 19)Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
10-25-2006, 01:55 PM #3
Registered
- Join Date
- Jun 2006
- Posts
- 217
That's 1 Ger21.....0 monte55
I was going to do it one step at a time so I didn't read too far ahead so I wouldn't get confused. The second step was get the software setup and that threw me off. Some of this I read means nothing to me as I'm sure it will as I progress along. Thanks for the reply.........Nick:withstupi
Reply With Quote
Posting Permissions
