Originally Posted by
cad-cam_master
Hi Todd, try this, I think is the easiest way to do it.
First make coordinate center on x,y=o R1.25, click continue and then go x=2.5, x=5, x=7 with their radius. Then make a point coordinate on y=1.25 and y=1.75, join them, and the point at y=1.75 translated by increment x=0.5 on the change tab. then just make the arc the by snaping. make a line tangent on that arc of 1.00, make a point at the end of that line and translated by increment to x=1.00, snap the arc and the rest is triming and tangen. then just mirror the part on x in the change tab and good to go. this took me about 4 minutes or less
Regards, Andres.
This is mostly the way I did it. I like to do 1/2 then mirror copy rotate.
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com