My machine has a different rapid traverse rate on the Z axis than the X and Y. How do I accommodate this in BobCAD-CAM v27?
X is 250 IPM
Y is 250 IPM
Z is 150 IPM

All axis are original rated at 100 IPM cutting

This machine can run faster than this because I have retrofitted it with AC servos and Teco drives, but for now I just want to use BobCAD, and I set Mach3 to run at the original specs above

There is no breakdown per axis in BobCAD, just two settings of Rapid Feed and Maximum Cutting Feedrate

Not sure what I should so. If I make the rapid feed 150, then it will be moving Z correctly, but X and Y will be 40% slower than they are capable.

What to do?

Should I just set the rapid at 250? I assume Mach3 will just say no and run Z at 150 max anyway?