Maybe someone can guide me it the right direction I am looking into purchasing a VFD for my would lathe
7.5 hp I am trying to set it up so it can run on single face.
Any help would be greatly appreciated.
Maybe someone can guide me it the right direction I am looking into purchasing a VFD for my would lathe
7.5 hp I am trying to set it up so it can run on single face.
Any help would be greatly appreciated.
You would need to find a manuf. that makes a 7hp 1ph unit, often the limit is around 5hp.
Check out Hitachi models.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Thanks for the reply
The motor is already install in the lathe so I don't want to pun a knew one I want to be able to change the speed through a controller plus I figure it woul be less noisier installing a VFD instead of a rotory phase convertor.
Any advice of where I can get one
Thanks again