Originally Posted by
tmallard450
I did some fiddling with the job zone function and it worked awesome! I clicked on the outer pocket edge and pressed job zone. The job zone button projected and extruded that curve and ignored all those pesky cross drilled holes. I had pre drilled a pilot hole in the previous opp for my tool to plunge in. Then all i had to do was tell the strategy tab to start from outside the part and the tool dropped right into my pre drilled holes.
Sent from my iPad using Tapatalk
I select waterline ops like this, not using the curve of the hole but selecting the area with job zone using the selection, and selector shown in red. I also deselect "clear flats" in parameters otherwise that can sometimes cause problems if the Z height isnt exact (marks the surface).