Does the Slant Pro control read G-code or only conversational? Or both?
I've seen pictures of the monitor, but I've only seen the "Fill-in the variables" screen-shot.
Does the Slant Pro control read G-code or only conversational? Or both?
I've seen pictures of the monitor, but I've only seen the "Fill-in the variables" screen-shot.
I have been using sprut9 for a few months learning how to setup lathe ops and reviewing the resulting g-code generated.
From what I see if it posts code as well as the simulation works it will be easy to get up to speed making parts.
Attachment 276884
Example clip of machine and some operations defined
md
So, I can go to the control and just manually punch-in G-code for a quick easy program?
It will read G-code programs, much like MACH did?
As far as I understand it. the conversation part generates g-code and you append those together to create a part or entire set of operations for a part.
or you could write your own and append that. I understand the Linux o.s. based program would have some file differences but other then that I see no difference.
The same program is now offered for the mill and it uses g-code posts from cam or conversation also.
md