I just started on a new job where I use AutoCAD 2014 and after a month of learning I start to feel that maybe AutoCAD really isn´t any good for 3D modeling. I have used Rhino 3D and Solidworks before which I liked and felt productive in. But with AutoCAD it just feel so slow and hard to do the small, everyday commands like measuring, changing drawing direction to Z, trimming surfaces/curves/solids etc. It just just doesn't feel like it was meant to work with 3D. And since it does cost ALOT of money, shouldn´t it work better?
Is it just me? A lot of you people seem to be working in 3D with AutoCAD, what do you think? Will I learn to work with it if I just give it time or will I never be as productive as I was with Rhino 3D?