Hey Tom,

I have just been experiencing a problem in KFlopWebNC. The M-commands 3 through 9 work correctly but 100 through 119 do not seem to be detected (or executed) while running a G Code. Any ideas?

I was also wondering how I could map G-Code commands to multiple axis. For this application I am using all 8 kmotion channels but two of these channels (6 and 7) are mirrors of other channels (4 and 5). This would be easy enough by itself but I also need to be able to stop and start these axis individually (assuming channels 4 and 6 are both the B axis I want to be able to turn off 6 whilst leaving 4 on and vice versa). I have tried disabling and re-enabling the channels but this causes an immediate abort of the G Code while using Kmotion.

Thanks for all the help so far, I think I'm close to finishing my app!
Mike