Hi all,
I'm new to Aspire, I've had it a while (just haven't used it much). I'm trying to create a simple fluting path using a smaller bit. I need to make a full half round flute 1 inch wide and 1/2 inch deep using a 1/2 inch core box bit. I had it close but the finishing path keeps rounding it off at the top. I just need a simple flute with sharp edges at the top. I'm sure this can be done easily, I'm just not very efficient with Aspire(3.0). I also have V Carve Pro which I use daily but just figured this would be easier with Aspire. I could go and buy a 1" core box bit but I only need 2 flutes 8" long for a one-off project and don't think I'd ever use the bit again. Thanks in advance for any help you can give me with this.
Jeff