Has anyone got rigid tapping working with a Lathe post processor?
I have tried but can't seem to get it to post any code for the tapping cycle.
I have turned on debug and it doesn't even seem to look at the rigid tapping lines so I must be doing something wrong.
This is V27 but that probably won't matter as I would think earlier versions would work the same.
Hood
Results 1 to 2 of 2
-
02-07-2015, 04:23 PM #1
Member
- Join Date
- Oct 2004
- Posts
- 832
Rigid tapping with Lathe post processor?
-
02-08-2015, 11:16 PM #2
Member
- Join Date
- Oct 2004
- Posts
- 832
Re: Rigid tapping with Lathe post processor?
Eventually found the problem, the line with the version number (see pic) was wrong. It had version 9.2, changing that to 10.0 cured it skipping the tapping cycle.
Now all I need to do is fine tune the post so that it outputs the tapping line correctly for the CSMIO/IP-A controller
Hood
Reply With QuoteSimilar Threads
-
Rigid tapping errors without rigid tapping installed
By dougputt in forum FadalReplies: 1Last Post: 07-06-2014, 04:44 AM -
What exactly is Rigid tapping? Why people always ask does it do rigid tapping?
By cjchands in forum MetalWork DiscussionReplies: 24Last Post: 05-01-2014, 07:02 AM -
Rigid tapping on Okuma lathe (spindle not live tooling)
By amgearinc in forum OkumaReplies: 6Last Post: 02-06-2014, 04:05 AM -
g184 rigid tapping okuma lathe
By pwanamaker in forum OkumaReplies: 7Last Post: 12-19-2012, 08:20 PM -
rigid tapping on Hitachi-Seiki HT-23J Lathe
By jbird68 in forum G-Code ProgramingReplies: 2Last Post: 09-21-2007, 02:02 PM
Tags for this Thread
Posting Permissions
