Yep, did it work, NOPE! went arduino mega 2560, RAMPS 1.4. works a treat.. using inkscape 0.91 and TurnkeyLaser Extension, and pronterface for uploads. hacked the TurnkeyLaser extension to turn on air assist if the check box it on. and a beep at the end of the cut.Originally Posted by Rolf_K
Thread: $32 CO2 Laser Controller
Results 1 to 20 of 263
Threaded View
-
07-23-2016, 07:04 AM #36
Registered
- Join Date
- Jan 2010
- Posts
- 53
Re: $32 CO2 Laser Controller
Robi
Reply With QuoteSimilar Threads
-
Laser engraving machine not firing laser from software or controller.
By JustTruckinng in forum Engraving MachinesReplies: 1Last Post: 05-14-2014, 04:14 AM -
Controller and Software for Laser CO2
By manolin in forum Laser Engraving / Cutting Machine General TopicsReplies: 3Last Post: 04-19-2013, 10:31 PM -
laser controller
By ne_bun in forum Laser Engraving / Cutting Machine General TopicsReplies: 9Last Post: 02-22-2011, 12:24 PM -
Best controller for laser?
By AustinT in forum Laser Engraving / Cutting Machine General TopicsReplies: 12Last Post: 11-02-2010, 02:34 PM -
Laser Controller
By canaantr in forum Laser Engraving / Cutting Machine General TopicsReplies: 6Last Post: 05-20-2007, 07:57 PM
Tags for this Thread
Posting Permissions
