Looking for a programing manual for a tree 425 with the dynapath control please help!
Looking for a programing manual for a tree 425 with the dynapath control please help!
Which Delta, 10/20, or 40/50?
Hello, I need the electrical diagram 570 050/S 801D2 For a TREE VMC 1050/40 with dynapath 20. Can you Help me? Thanks, Jorge
Here is the EIA/G-code section. It would take me a good long while to scan in the rest though.
I do not. I have a 325J so the wiring diagrams are different. You can email ZPS USA and see if they have a diagram for you, but you might have to pay for a copy. Someone on here might have one, but its hard to say. This forum isn't exactly the most active on here so you might be waiting a while for one. I can get you one for the 325J, but I am not sure how much help it would be as I am pretty sure every machine uses a different wire numbering system. You can also check over on Practical Machinist to see if someone over there has one, but you might also be waiting a while there as well. Do you have a specific problem going on or is it just to have for maintenance?
here is the complete dynapath 10/20 manual
https://mega.co.nz/#!BQMRhYbR!yHHfvu...pNyqsPfGZpwJmI