Here is the EIA/G-code section. It would take me a good long while to scan in the rest though.
Here is the EIA/G-code section. It would take me a good long while to scan in the rest though.
I do not. I have a 325J so the wiring diagrams are different. You can email ZPS USA and see if they have a diagram for you, but you might have to pay for a copy. Someone on here might have one, but its hard to say. This forum isn't exactly the most active on here so you might be waiting a while for one. I can get you one for the 325J, but I am not sure how much help it would be as I am pretty sure every machine uses a different wire numbering system. You can also check over on Practical Machinist to see if someone over there has one, but you might also be waiting a while there as well. Do you have a specific problem going on or is it just to have for maintenance?
here is the complete dynapath 10/20 manual
https://mega.co.nz/#!BQMRhYbR!yHHfvu...pNyqsPfGZpwJmI