We got all the parameters up all the bugs worked out with the exception of when the machine goes to feed in G01 it stops and sits there like its waiting for something.
no lights no error alarms. spindle stays running coolant stays on etc etc even picks up tool offsets with no problem just wont feed at no mater what feed rate we give it.
since we had to add parameters in the control I am assuming one is either missing out of the book or one that was written down is wrong.
the machine moves in dry run when you have a G01 Z-0.2 F0.010 . when you try to run it off dry run it stops
as a test I programmed in a G98 F1.0 Z-1.0 then tried a G98 Z-1.0 F.05 even a F.5 and a F15.0 also tried feed rate after Z-1.0 the feed rate stayed the same extremely fast as if there was no change in the rates of feed. and the speed control override doesn't work on the G98
yes the spindle is turning as its a normal program that we run in other machines
the machine in question is a knc-45 miyano with a ot model a control
ran numerous sample programs in the book thinking there are different codes for the miyano but to no avail. all have the same exact results.
Thanks
Delw