I just installed a 4th Axis (HRT-160 w/Chuck) on a HAAS TM2 and need some assistance on how to use it in conjuction with FeatureCam 2012. Never used 4th axis before so any insight would help.
Thread: FeatureCam and 4th Axis
Results 1 to 2 of 2
-
01-11-2015, 02:03 AM #1
Registered
- Join Date
- Jan 2012
- Posts
- 4
FeatureCam and 4th Axis
-
01-26-2015, 12:32 PM #2
Junior Member
- Join Date
- Jul 2010
- Posts
- 369
Re: FeatureCam and 4th Axis
warrant914A
Most important part using FC 2012 is setting up your UCS correctly.
Once it is set, you can not change it, in this version.
You can change it in later versions of FeatureCAM.
I hated this about FC... and they fixed it I think in 2013.
Is there anything specific that you would like to know?
Good Luck~!:cheers:
Reply With QuoteSimilar Threads
-
4 axis Featurecam
By Smokio in forum FeatureCAM CAD/CAMReplies: 5Last Post: 12-08-2012, 01:12 PM -
Mach3 Featurecam A axis not working
By Bell 430 in forum Mach MillReplies: 0Last Post: 05-14-2012, 01:54 PM -
Post Processor FeatureCam 4 Axis/Mazak Nexus
By Xaviersierra in forum Post Processor FilesReplies: 0Last Post: 04-14-2012, 02:12 AM -
Need 4th axis help in Featurecam 2008
By Mottbone in forum FeatureCAM CAD/CAMReplies: 8Last Post: 09-21-2009, 06:08 PM -
Featurecam Lathe Setup X axis MAch3
By whiteriver in forum FeatureCAM CAD/CAMReplies: 0Last Post: 02-21-2006, 12:04 AM
Tags for this Thread
Posting Permissions
