[Scopolomine]

I have one of thes which ha suddenly dropped in power.
replacing the tube and realining the mirrors has had no effect.
i suspect the psu or control circuitry to be faulty.

are there any known problems with these please ?

what is my best course of action ?

[herby08]

hi there
like I sayd before to many people you need to tell more what kind you got what motherboard , what software etc, because there so many different machnes out there all called K40 what actually just a group for 40 W laser ( what actually is not 40W just around 30W)
greetings
waltfl

[Gweikelasers]

Hi,
Yes, just as herby said, please give us more info about the machine. Also is there any signal light on the psu? That will be helpful to find out the problem.

[Scopolomine]

Its one of these, late model with the plastic cover on the pcb.



i have no idea about part nos etc
50W CO2 LASER ENGRAVING AIR ASSIST U-FLASH DISK ENGRAVER CUTTER MODERATE COST |

[fixtureman1]

in your software when you edit the color if the cut is the min power set low If I set mine at 30% on the minimum power and try to cut at below 5 mm at 85% power it shows that I am only cutting at 30% according to my meter. When I bump the minimum power up to 85% it cuts correctly. I added the meter to keep track of the power. hope this makes sense