[6345789]

Do a simple name with a little text and the laser starts to print (?) quickly. Now with 121 names plus a header, she takes forever to upload...after 10 minutes...still nothing. I do remember hearing a bell or beep sound. Is there a solution to this problem? Could onboard memory be the problem? HELP!

[herby08]

hi there
you need to give a bit more data from your machine , what motherboard, what software, how you connect ( USB?), because there are so many different K40 machines out there
greetings
waltfl

[6345789]

Attachment 260128

Laser Control System For Cutting And Engraving Machines - Buy High Quality Laser Cutting And Engraving,Motor Control System,Universal Control System Details Product on Alibaba.com (Control Board)

RDWorksV8 (software)
CorelDraw12

Connect by USB to computer. Optional USB memory card

Have had for one week. Problem occurs in both CorelDraw12 and RDWorksV8,

Print header separately...Prints!
121 names divided into three columns...Long Processing (more than 10 minutes) STOP.
Divide one column into half...Prints!
All printing is on top of each other no matter where it appear in the layout.

[6345789]

Laser control system for cutting and engraving machines

http://www.alibaba.com/product-detail/Laser-control-system-for-cutting-and_1036981034.html

[herby08]

hi there
format the machine memory this will eliminate any remains sometimes there are bits and pieces left in the memory and block this section.
it also could be a faulty memory chip.
depending on the design check how big the file is if it is over or close to 100mB then it will take a longer time or would not load completely .
greetings
waltfl

[Heydays]

Hi. Same machine here arrived approx 10 days ago. Still finding my way around it but the 'beep' sound you heard tells you there is something not correct with the settings. i.e outside of engraving area for instance. If you look in the little control panel on the machine, the beep is followed by a message in the panel telling you what the problem is.

[6345789]

https://www.youtube.com/watch?v=yNSL...Gg2kmkYzR6OIWg

Please see link above. Don't know how to format memory in machine other than turning it off then back on and no page of text will be over 10MB. Tried it again today with no results.

[Heydays]

https://www.youtube.com/watch?v=yNSL...Gg2kmkYzR6OIWg

Please see link above. Don't know how to format memory in machine other than turning it off then back on and no page of text will be over 10MB. Tried it again today with no results.

When it beeps check what it says on the monitor in the control panel on the machine. Pretty sure the last two names are outside of the print/scan area, hence why it wirks when you remove them.

[herby08]

hi there
I did not recognize that you have the Rdcam. ok it looks to me that the page is outside of the printing area try to turn the page 90 degree and see whats happen.
it has nothing to do with the memory its just that the page or something on this page is outside the engraving area.
greetings waltfl