Hey everyone,

Happy Thanksgiving to everyone in the states.

I am finishing up my electrical control cabinet, and I am at the point where I need to wire up my motor connectors permanently. I am using 4 pin motor connectors, and I am not clear how to attach my wires to the connector pins.

The male side looks pretty straight forward, I can just push the wire in and solder it and it should hold well, but I am not clear on the female side at all. I suppose I can solder it there too, but I am wondering if there is a better way to do it?

Here is a pic of both my male and female side where the wires connect. The male is on the left, and the female is on the right. Any suggestions would be helpful.


Attachment 258550