Hi,

I have kind of an odd problem with an isel IMC4-M interface while writing my own software: I am able to control the speed of the motors but the time the motor needs to speed up ( and to slow down ) seems to be fixed in an eprom. So if I try to move just a few steps the speed setting does not show any results.
Does anybody know anything about different eproms for the IMC4-M ( Isel refuses any kind of support and now claims that the guy who told me about it is not competent ! )

There are rumors that the IMC4-M was not build by isel on the first hand - what may be the reson for their bad support. Does anybody know who buildt the interface?

Thank you

Matthias