I'm looking for a recommendation on a coolant system for A BP II CNC Knee Mill.
* I don't particularly like the idea of a mister as I don't want to be inhaling the mist.
* The flood type seems like it will be a mess and I have read that it gets all over the shop also. I would be willing to build a short Plexi cage around the table to catch the oil. This strikes me as the best coolant method, especially for CNC setups.
* Just Air. This blows away the chips and it cools the end mill. Although I'm not sure it cools enough
* It would be nice if I could turn it off and on via CNC control.

I would just rather buy some affordable system rather than make my own, although I would consider the DIY approach if there are no low cost options.

Recommendations? :cheers: