[silenthaha]

Dear all,

Good Day

Currently, I have a problem with the lubricant system. I had change lubricant device from oil to a grease. Then I made some modification on that lubricant system (the lubricant operated only twice per day by using external timer) . But suddenly when cnc is running around 15 minutes this machine pop out low pressure alarm. my question is how to disable lubricant function on the Series 31i model A?

[underthetire]

Dear all,

Good Day

Currently, I have a problem with the lubricant system. I had change lubricant device from oil to a grease. Then I made some modification on that lubricant system (the lubricant operated only twice per day by using external timer) . But suddenly when cnc is running around 15 minutes this machine pop out low pressure alarm. my question is how to disable lubricant function on the Series 31i model A?

Has nothing much to do with the control, you can either change the ladder, or jumper the pressure switch and hope the builder didn't write a check in the ladder for rise and fall of the lube pressure.