[Patrik]

Hi,

I'm currently looking at bidding on one of two machines but cannot decide on which one to go for and was hoping that anyone of you could give me an opinion!

Both of them are Leadwell machines one being the MCV-0P model the other one being a GMC-350, both of them with a Fanuc 0-M controllers.
The MCV i can find some info on and some videos but the GMC seems to be a tricky one, nothing comes up when googled. Does anyone have any experience with this machine?

I dont know the X Y Z travels on the GMC?


I'm not gonna be using my machines in production, however i would like to cut some steel (free cutting type steels, no though alloys) will they both handle this?
Model making is going to be my main use for the machine so i'm not really looking for .0001" / .001mm in steel.

Your opinion is very much appreciated!


Many thanks in advance

[lmostafa]

Hallew
i have mailing machine LEADWELL MCV-OP WHIT FANUC OM
INEED PARAMERES DIAGNOSTICS AND MACRO PROGS
THANK YOU TO SEND it me by email:[email protected].
Best regards