[tc26]

I am using MCX6 to post code for HAAS mills.
When I try to use cutter comp at the machine control, often times I get an alarm.
The factory told me it is because some program moves are equal to or less than .0002"
I have tried changing some of the tolerances in the MCX6 System Configuration without any luck.
As a result, I program for actual tool size (I am grinding with diamond tools) and must generate new code for every change in tool diameter.
Can anyone help me out?

[Superman]

What "Comp Type" are you using ? (In Computer, In Control, or Wear)

What Lead in/out settings you use for that comp type ?
( line distance, arc sweep, & arc size )
- I do know that the arc sweep angle has created some problems for me on occasion
-What setting do you use for cutter Roll at the corners ?

What size of "cutter" are you talking about, & what amount of "adjustment" do you need to achieve ?

[tc26]

I have tried programming to the tool centerline (.500" end mill) and comp at control -.035" (.465" end mill).
I have tried programming to edge of tool and enter actual diameter at control (.465" end mill).
Errors happen way past point where tool enters the cut.
I am contouring complex 3D surfaces with many small point to point moves.
It is some of those small point to point moves that cause the alarm.