[jusaboy]

Im using Write wizard and it´s working properly. I want save produced g-code for future use. In mach3 i go to edit g-code and then save the code SaveAs with different name like mytext.tap.
Next time I start Mach3 and loading g-code named I did save, the text is loading but it comes some swirls, like rounds too. The swirls is visible in g-code and graphigal window.
What goes wrong ???

[ger21]

You're IJ mode is incorrect.

[jusaboy]

Thanks !!! ger21 It was very good tip about IJ-mode. Good tip and little study for me about IJ modes.... great !
I did make IJ-mode commands to g-code and works fine. Needs G90.1 with files from Write Wizard (other way is the init string in general config, but i dont know what happends my other files.