[braided]

hi igorko
if your CRT not going on when you push the on switch then may be your memory section disturb.if you have your machine parameters then you can machine on with delete and reset and cancel button.may be you have need repeat this two to three time and your screen will on.because i have solved many problem with this when screen was off but supply was ok you can try thi i think you will clear.

[peloflex]

hi igorko
if your CRT not going on when you push the on switch then may be your memory section disturb.if you have your machine parameters then you can machine on with delete and reset and cancel button.may be you have need repeat this two to three time and your screen will on.because i have solved many problem with this when screen was off but supply was ok you can try thi i think you will clear.

Hello-braided!

Thank you! I have tried your trick and it worked!! We have (w/your help) recovered the graphics and the CRT screen all together. However, I am not able to get it to a 100% functional yet, I am afraid that I am not so familiar with this particular machine. So far I have done myself as much as possible to reload all the missing parameters,(manually one by one) but there is still a couple of details that I am not seeing. I get a 1002 alarm every time I intend to hit the run cycle on MDI mode.
The machine goes all the way from power-up to standing-by status with no errors nor alarms at any of the electronic components, it is all clear and good to go. But one thing does not do, I cannot move any of the axis using JOG or ZEROING AXIS, so no manual movements available. I would suspect it has something to do with a parameter or a few of them might need revision. I loaded this 18M with a sheet of data that came with this USED Supermax. It will be greatER help if you have any additional info to share that takes us to the next level. Well appreciated.

Flex

[guhl]

Hello-braided!

Thank you! I have tried your trick and it worked!! We have (w/your help) recovered the graphics and the CRT screen all together. However, I am not able to get it to a 100% functional yet, I am afraid that I am not so familiar with this particular machine. So far I have done myself as much as possible to reload all the missing parameters,(manually one by one) but there is still a couple of details that I am not seeing. I get a 1002 alarm every time I intend to hit the run cycle on MDI mode.
The machine goes all the way from power-up to standing-by status with no errors nor alarms at any of the electronic components, it is all clear and good to go. But one thing does not do, I cannot move any of the axis using JOG or ZEROING AXIS, so no manual movements available. I would suspect it has something to do with a parameter or a few of them might need revision. I loaded this 18M with a sheet of data that came with this USED Supermax. It will be greatER help if you have any additional info to share that takes us to the next level. Well appreciated.

Flex

you also should to enter PMC parameters. timers, counters, etc.