586,125 active members*
2,887 visitors online*
Register for free
Login

Thread: Error?

Results 1 to 3 of 3
  1. 11-21-2014, 08:24 AM #1
    Atomic_Sheep2
    Atomic_Sheep2 is offline Registered
    Join Date
    Sep 2011
    Posts
    17

    Error?

    Hello,

    I post processed a part and then ran it in Mach3.

    The first thing I see when I open the file is the program jumps to line 75 and in the status box I see:

    "Radius to end of arc differs from radius to start line 75"

    I have no idea what that means, but I'm interpreting this as an error because in the preview window I don't see my part program and nothing happens when I try to run the program.

    Any ideas? Suggestions?
    Reply With Quote Reply With Quote
  2. 11-21-2014, 01:52 PM #2
    ger21
    ger21 is offline Community Moderator
    Join Date
    Mar 2003
    Posts
    35538

    Re: Error?

    It's most likely due to an incorrect IJ mode, which specifies the center point of an arc.
    The error means that an arc with the specified radius will not end at the specified location.
    Gerry

    UCCNC 2017 Screenset
    http://www.thecncwoodworker.com/2017.html

    Mach3 2010 Screenset
    http://www.thecncwoodworker.com/2010.html

    JointCAM - CNC Dovetails & Box Joints
    http://www.g-forcecnc.com/jointcam.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
  3. 11-24-2014, 09:04 AM #3
    Atomic_Sheep2
    Atomic_Sheep2 is offline Registered
    Join Date
    Sep 2011
    Posts
    17

    Re: Error?

    I think I fixed it thanks.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Fixed BMDC Error, now have overactive feed error. Help needed.
    By victorgallas in forum Bridgeport / Romi Lathes
    Replies: 3
    Last Post: 11-01-2014, 11:22 PM
  2. Fixed BMDC Error, now have overactive feed error. Help needed.
    By victorgallas in forum Bridgeport / Romi Lathes
    Replies: 1
    Last Post: 10-20-2014, 01:56 AM
  3. Strange error in machine defintion manager (Error occoured in IOF chook: )
    By CNDaniel in forum Mastercam
    Replies: 0
    Last Post: 07-17-2014, 04:12 PM
  4. Cincinnati Sabre 750 850SX spindle error 16541 Fanuc error AL 12
    By markp in forum Cincinnati CNC
    Replies: 0
    Last Post: 05-05-2013, 05:40 AM
  5. Yaskawa Servopack error: A.D1. Motor Load Position Excess Error
    By Syphonics in forum Servo Motors / Drives
    Replies: 0
    Last Post: 04-26-2012, 07:53 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules