HELLO GUYS

A few months ago finalize my project in a plasma cutting table 5x10 ft, my compressor capacity was very small so I could only make continuous cuts of 3 minutes Now I have a compressor 80 gallon thing is very different there has been a great problem after 7 or 8 minutes of continuous cutting the y axis misalignment around 3/8" I tightened the screws on the gears and racks all is well fixed , I reviewed mach3 settings and everything is the same in the two motors that move the Y axis someone something happened thank you very much for your support

add pics


Attachment 256106

Attachment 256104