This low hour (hobbyist owned) 5 axis machine is for all intents and purposes a pro.
I Put the order in for a Novakon Pro with the new stand as it is ready for the ATC and new Novakon enclosure that is in the developmental stage I am working in concert with Novakon on the prototype of this enclosure and decided it would be easier by far to have the pro and upgraded base to design from and being a Demo center for Novakon I thought it only right to have the latest machine to show potential customers.

Asking $10,500

Located in Charlotte NC

Here are the specs;
NM 200 series 2 up graded to a pro 2hp 1500 watt 150 to 6000 RPM AC VFD spindle motor
4th and 5th axis,
Novakon power draw bar, and input for probe
breaking resistor that stops spindle in 1.5 sec from 6000 RPM
Twin LED work liights
stepper motors on X,Y, Z axis
Sunfar 300 controller,
Increased flow coolant system with a wash down hose. Based on Ray L's design
On board computer and Mach-3
Enclosure
Table is a massive 38.5 x 12 and will hold 850 lb work load.
Table Travel is 24 inches in (X) 16+ inches I extended the front of the tray to enable the extra (Y) travel and 11.5 inches in (Z)
Machine weighs over 1,500 lbs
approx. 470 hours , excellent condition
I have literally spent more time upgrading this mill then running it.