Quote Originally Posted by chich2 View Post
Bill,
Im sorry to say that I do not have any literature from the old control. I do have some old hardware though. There is a moderator here on cnczone called "Al The Man" he knows ton's about Fanuc Controls. You could PM him as he probably has manuals he may email to you.
Where are you based? Country? State?
Hello Chich,
The information is Machine Tool Builder specific, the PLC (PMC in Fanuc Speak) is written by the MTB. I'll be able to work through the Ladder, its just easier if you can identify the I/O without having to trace wires to get the I/O address.

I'm in Victoria, Australia.

Regards,

Bill