[kmuller]

Got used Kitamura with 16i controller and when reset is pressed, the G54 values change to zeros. Is there a parameter to change this?

Thanks for any help.

[fordav11]

check/try...
1201 bit 7 = 1 (upon reset, work coordinate system is returned to that specified with G54)
in this case a reset will always return you to your G54 workshift

1202 bit 3 = 0 (local coordinate system is not cancelled by reset)
in this case a reset has no effect on any workshift setting and will remain valid until cancelled with another work coordinate system G code.