[Beansdiesel]

Ok, so trying to figure out the thread mill path in V24. Currently trying to cut 1 5/16" -12 threads. I have the hole size, put in the thread diam size, thread pitch (.083) and what I think is the right thread height (.040). Once done my fitting will start in it but feels like its too much interference. It seems like no matter what I try it will not cut the threads any deeper. I can go from .040 to .200 and it will cut what seems like the same exact threads. Not sure what else to try other then making the dia. size bigger but really dont want to do that.

Thanks.