Hey guys.
New at this. I use Turbocad normally, so some of the terminology is familiar. Some actions are too. That is about it though.

I have watched several video tutorials. Mainly for specific functions.

That is where I actually have any trouble with trying to do something.

I have my part almost completed with threaded holes, correctly placed slots with fillets and chamfers.

I am now attempting to add text to be engraved onto what was not the original drawing plane. I am having trouble placing the text in the right spot as well as orientation.
I found the correct font to use for engraving. Same one I use in Turbocad basically. Just stick figure font.

I also attempted to first reorient the part before adding text.
I seem to be getting errors trying that too.

Both of these tasks are pretty elementary in the scheme of it. That means the tutorials seem to miss that.
Any hints or video links?
Thanks.