I have a Baldor DC Brushed Servo with built in Encoder. I just want to use ABZ but the spec sheet doesn't show the separate channels any ideas
I have a Baldor DC Brushed Servo with built in Encoder. I just want to use ABZ but the spec sheet doesn't show the separate channels any ideas
You just use the 3 main ABZ strange it does not show which is the /A /B /C complements?
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Al
The mains would that be pin
D for Z
E for B
G for A
Thanks Al
RAF.
Actually you can use either, they are essentially both the same, one just an inversion of the other, as long as you use all three of one type.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Thanks Al for your help,
the tech was shocked that it didn't show the channels also.
Is there a way to figure out which is which channel if info is not available?
Thanks again for your help
RAF.