Hey

I am new to using G112. Before crashing a machine..... I was hoping I could get some feedback on some code so maybe I can have a little confidence when running it. I need to make a round hub that is 6.3125mm off of center. The hub itself is 25.35mm in dia. I am hoping to do this by milling it using G112.

Any input would be greatly appreciated since this will be my first shot at using it. I am also not sure if i have to double X values

Would this work?

G112
G98G1G42X37.975C0.0F1000.0
G3C12.675X12.625R12.675
G3C0.0X-12.725R12.675
G3C-12.675X12.625R12.675
G3C0.0X37.975R12.675
G1X50.0
G1G40X62.0
G113

Thanks