Hi Tom

I have had random freezes of KmotionCNC.
I was not able to notice anything that I did to cause this, but it never happens during a g-code run. I suspected a file access delay so I changed my HD to an SSD. I still get them.
I changed the routing of the USB cable.

Today it happened after editing the g-code, hit run -> freeze.

What helps is unplug USB cable -> the program unfreezes, error message appears, plug the USB cable back in -> continue to operate without any hangups.

Since nobody else has this problems, I am asking myself how to diagnose the cause. The only thing that is unique is that I am working in lathe mode.

Do you have any idea how I could solve this?

Regards

Leo