Originally Posted by
inov8r
I have the version that doesn't look anything like the one you have pictured. I suppose it is the Tormach version. By setting up the tool table I suppose you are saying to set the dia. only since you dont know the length? Then as each tool is called, I touch them off and hit the "set z" in the offset page and the value I entered in the block height, which should be the value my original facing tool touched off with, will be entered into Z? I will see if I can reconcile the two versions of offset pages and give it a try. It's actually not too big of a deal to write down the original touch off value and reenter it into z on each touch off. But if i can enter this number just once and then hit a button on each touch off, it will be nice, and less chance of making a mistake. Thanks for your help and input!