Experienced a new thing this morning. Powered down the machine last night after running a custom fixture base for a large piece run. Came in this morning and all the fixture offsets were at the max travel position and also all the TLOs were reset to zero. This seems like maybe some sort of a memory/battery back-up issue, but I don't think the problem is related to the PC side because no problem booting to the solid state disk on module this morning and the date and time show correct on the screen. I also would have though the tool and fixture offsets are stored in non-volatile memory.

Anybody have any insight as to how it might have lost these? I haven't tried powering down again to see if it repeats yet I have to get some parts out the door.