No mirroring problems? I want to make mirror-surface letters.
Thanks in advance for your answers.
No mirroring problems? I want to make mirror-surface letters.
Thanks in advance for your answers.
Last edited by comrade; 04-24-2016 at 10:47 AM.
Co2 laser will cut the non relective material cleanly but meltback gives poor edge finish plent of youtube vids out there notice edge quality and burning K40 35w type lasers would be worse
https://www.youtube.com/watch?v=BcP4YyONitc
https://www.youtube.com/watch?v=uVBWzV4wt4Q
Polycarb cuts like crap. Been meaning "one day" to change out air assist with nitrogen and see if that eliminates the burning.... And yes, I would be checking that nitrogen is the right gas first!
Sent from my ASUS_Z00TD using Tapatalk