Re: WCS orientation when opening part
Are you actually using Mastercam X for a newer version. if it is actually are using Mastercam X there is no Dynamic Planes or Dynamic WCS being the one would being the right one to use. bu,t so you know that solid works top is Mastercams Front so if you go to Planes Manger and set it to Front it will set the part just the same as SW.
PS use this older video from X2 to use the WCS in the older version. If you are using a newer version of X4 or higher you can go back to the same Youtube site to see newer options.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .